Recent content by Donna Argueta

Thank you for your reply. Didn't know about taking the shield off. I do the roll out on my graphtec. Didn't think about doing in on the new roland. UGH! I'm used to the xc540 and I was able to control the speed. Thank you again for the advice. I will definetly try it out.

I couldn't find one either, just hoping i was wrong.

Of course. It goes so fast when your trying to cut 12ft runs and want the alignment to be the best it can.

:rolleyes: possibly.

Is there a way to slow down the speed of how fast the printer reads the crop marks?

We mostly do shirts, very little rigid. I do use the tacky paper for apparel though. Thank you for all the information, we just didn't want to spend the money on a new press if we were going to have issues. Now for the boss to get me a new ordered!

Thank you for the information. We have an old 1990ish Hotronix heat press. She's my old faithful. I didn't want to spend the money to get a new one, if it was going to be a hassel. We use Beaver Paper TexPrinte Supreme TT 92 GSM Adhesive paper for our apparel orders

Does anyone use an automatic pop up heat press, like the Dual Air Fusion IQ for dye sublimation? I was wondering if it causes the print to move when it pops of and makes the print look ghosted.

When I turn on the machine, the tool carridge slides all the way to the right, hits the side and starts beeping. Usually, i carefully slide it over, turn it off and turn it back on and it works fine. Now when it does it, the tool carridge won't move.