Recent content by guillermo

I do laminate anything flat on my 65" laminator, even up to 1/2", what I do is stick the edge of the vinyl, feed about 2" into laminator, flip the vinyl to go around the roller, then remove the liner/backing and feed material, it will be no bubbles.

I will try General Formulations 226 HTR (high tack removable) look it up, that is another option, 6mil thickness and no need for lamination.

I do not know where you are, but try to contact the manufacturer, 818 8864000 I buy from them direct and I pick it up, (I am about 6 miles away) Or contact Ordway Sign Supply, www.signsupply.com this is a distributor. I believe both places have the ink for $45 a bottle of 500ml and they are in...

We have a Mimaki JFX200-2513, but we changed the printheads 2 times, I will research the price of parts most frequently used and go from there. (each printhead cost is about $4500.00)

I have a new print head installed, and every print comes about .03" off, it prints in the pin, I have to set the image to print .03" to start at the material, how do I set the machine to print exactly at the material, when placed in the bottom right corner?

thank you. I have seen that in wall paper, just a new building in campus.

is this encapsulating (hot lamination) or it is just cold lamination? check for rollers if there is a flat area, (when not in use, leave the rollers open, to prevent becoming flat)

If you try to print with a latex printer, watch out for the drier, to much heat will warp the material.

I keep an eye on the forum, but did not see this before. without reading some of the suggestions, I was going to tell you that one of the best options is to print reverse on clear adhesive and then apply regular white vinyl to use it as white background, I did it with some stickers to have text...

....... I regularly use WD40 to remove the left over glue when removing adhesive, it works perfect for me; let it soak for a couple of minutes or little more and then use a plastic razor, or squeegee; I sand the squeegee to sharpen the edge and have a wider area, more than a regular plastic...

Hi I agree with CanuckSigns and Gary Wiant, I did exactly as they explain and I do not have that issue, only when I do a lot of engraving, I clean the lens, other than that, I check it before any job and I do not have to clean it.

thank for the time to respond to me. for the updates to 5.5.1, from 4.0.0, all I did is transfer the folders in the old computer to the new computer, it worked, I am at 5.5.1, but I do not have a local printer, I will read the manual you sent me and will try with the disk, when installing it...

I jump into this and hope my info will help. I had an issue a while ago, the printing was skipping about 3 millimeter, but it was about every 12" apart, I was going crazy, until I check the motor behind the control panel on a Roland RE 640 and found out that a little drop of ink was on the...

Great information about the wall wrap and wall covering, but what is a double cut?.

JimDTG thas is correct, with these printers, I do not have to change size when I print different sizes, we print different sizes, specially 24x36, 18x24 and 12x18, they come with bleeds or crop marks, instead of cropping them in versaworks, I create these printers with that specific size...