I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I have a latex 335 that we have been using for years with no problems and now for some reason all of a sudden on this briteline vinyl we have been using for years with the same profile as always our prints are coming out as shown in the attached image. I did a test print and it seems to be...
The tech never installed that on our computer when we got the printer over a year ago. I have tried downloading the epson edge and it always says it is complete and I can open it at the shortcut but there is never a shortcut or anything for me to open when I finish the installation.
Does anyone know of any good profiles for the S80600 to use with Flexi? When we had our printer installed the tech just went with a basic 3m profile and I haven't found too much other than onyx profiles and wanted to try something different with our substance media. I know we can get better...
Does anyone know what would cause this? When printing it sounds like the motor is making a different noise and the foil just seems to stick along the vinyl and not roll up into the other roll and just causes it to break after a few inches of printing.
Our tech just showed up finally and it looks like one of the heads they just put in is bad. We were printing on single head mode and it stopped doing it.
Yes, these are the same ink that was in the machine before the head swap.
Yes even after doing some cleanings it is still the same. I have been doing tests with the same print file and it does not have any pattern. One print it will show up in certain spots and the next it will be in other...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.