I Need help with the Print & cut

[Boogyman]

Hi Everyone,

Hope your all doing fine? I'm trying to Print & Cut on my VersaCamm SP-540V. I not able to cut a full bleed, theres' always a bit of white.

Can anyboby help me?

Logo done i Illustrator CS2

Thank you! :Canada:

[Fred Weiss]

If you are using the same paths for the print image as you are for the cutpaths you are asking for more accuracy than is reasonable to expect. Try creating outlined paths of .02" to .04" and put your fills into them and designate the original paths for just cutting.

[Boogyman]

By the the thanks for the great service, I both a few weeks ago a victor art from you!

[Fred Weiss]

By the the thanks for the great service, I both a few weeks ago a victor art from you!

:cool1: :thumb: :thankyou:

[High Octane]

You sell "victor" art now?

[Fred Weiss]

As should appear casual to even the most obvious observer, our profession does not garner high marks in the area of spelling, punctuation or grammar.

[bigbly]

yes Fred it is casual to this obvious observer.. I often wonder what strangely spelt signs are out there..

[Fred Weiss]

As I often remark in my store to customers and co-workers alike

It is a detail business. :rolleyes: