Cleaning the Gerber printer spokes?

[Jessica]

Does anyone have any tips for cleaning the gunk off printer and cutter spokes? I pick at with my fingernails or with a dull knife, but it takes forever. Any good ideas??

[GB2]

Take the pen tip out of a BIC pen, or similar, and use the pen cylinder to clean off the sprokets. They fit perfectly and clean them right off, with a little help from a paper towel and some isopropyl alcohol if needed.

[B Snyder]

Clear BIC pen with the end cap removed.
I've heard some people use a cheap electric toothbrush.

[Gino]

Elbow grease and lots of it.

Later on a few :beer :beer


Always works for me LOL

[Geary]

I used to use alcohol and a toothbrush after getting the big chunks off with a knife. :wink:

~Gear

[Mike Paul]

A little adhesive remover on a Q-tip softens it and makes it much easier.

[canadianchef]

Here is a pdf manual for the gerber gs-15 printer (that I also Own) for your information of care and maintanance.
Warm Regards !
Terry:Canada 2:

[Replicator]

I was informed by Gerber 2 days ago to use compressed air in a can !