ID on a stripe?

[Sabre]

Hey guys, just wondering if anyone has seen this stripe in a package available commercially. I have a customer with his heart set on it and I told him I'd see what I could scrounge up.

Thanks in advance!

[Sabre]

Sorry for the ass picture quality. :|

[WVB]

There are just so many of these tribal designs everywhere, but you should be able to trace this out and get pretty close. Check with decalFX.com

[grafxxx]

yeah what tvg said,get some tracing paper and go to town that is pretty straight fwd design. well that is how i would go about it so you don't waste hours searching on the net for it.

[Tim D]

And make sure you line it up properly. It should be moved forward a bit. That will also help around the door handle.

[Sabre]

Yeah, I figured I could reproduce it fairly close but don't want to rip off someone's stripe without at least putting out some effort to buy it. Or am I on the wrong track and this is too simple to worry about and I should just recreate it?

[Sabre]

And make sure you line it up properly. It should be moved forward a bit. That will also help around the door handle.

This was his sample to go on a completely different vehicle, I'll probably massage it to work a little better with his handles.

[imaSIGNr]

Even if you did find this same design, chances are it's been distorted to fit this particular vehicle...Do as others said and remake it.....Also if you got a disk with tribal flames such as this and showed a few to your customer, I bet you could sell him just as easy on a different one.

[Creative_Lance]

I traced it for you...you do the rest!
hope this is helpful. let me know and i will send you the EPS.

[imaSIGNr]

This is from the mega 2 disk

[grafxxx]

i got a lot of tribal car graphics from clipart.com and i will say most likey that they got those graphics from a clip art program.

[Sabre]

Hey guys,

I wasn't looking for a freebie or a handout, but I do appreciate everyones effort and advice. I'll probably just rebuild it, as suggested by most. I wouldn't dare come on here and ask for someone to rebuild another's work so I could run some easy cuts and make all the money.

Thanks again!