trailer

[WOODBS]

i have a 14' trailer to wrap. first one, and have noticed most trailers are wrapped with panels running vertically. i only have a 30" versacamm, would it be better to run them horizontal?

[Gino]

Usually you run your seams the same way the seams on the sides [of the substrate] are running. You'll just have a few more, but it still beats the edge at 11.75 seams.....lol

[Craig Sjoquist]

after doing my 1st print of only 2ft wide going vertical makes best sense ...be alot easier to apply on a trailer... and yes the seams ...

13 folds

[Pro Image]

Gino is right vert. is the way to go on a trailer...................

[Flame]

All the way. Makes for more seams, but it will honestly come out cleaner.

[high impact]

Vertical on a box - that's the only way we've done 'em. Just like wallpapering a wall. lol

Start in the rear and work toward the front so the seams face the correct way for wind drag.

[WOODBS]

thanks guys

[johnnysigns]

it can be done horizontally, but it may be more install intensive for you to manage that large of a piece. if you go horizontally, install the bottom piece first.

[WOODBS]

good point i think i'll go vertical