Graphtec FC3100 setup

[joest]

Hi
I've just bought one of these but have no manual. When I turn it on, "Roll1", "Roll2" & "Sheet" appear on the LCD panel, and I cannot make anything else come up so I've no idea how to control the Force, Cutting Speed etc. Can anyone help?
Joe

[GregT]

Welcome to the board from PA

Put your roll in and align it, press "Roll 1" and wait. Head will go back and forth.

Once that stops, press "Condition", using the arrows to change (1)force, press (2)speed and change that to what you need.

Then send a job and see how it cuts.

[GLARUS]

Do you still need manual for fc3100?