How to Get the VJ1204 to print 48-in

[Derf]

I have FlexiSign Pro 8 for PC and I have a VJ1204..

the specs say it can print exactly 48-in however I can't seem to find the margin settings or something that is keeping it from printing a full 48

Does any one know how to set this up to print a full 48?

Thanks

[Gene@mpls]

I don't have one- but I think I read somewhere that it would print 48" only
in unidirectional.

[Derf]

I will give that a shot.. thanks Gene@mpls

[dclet]

You need 51" inch material to do a full 48"

[randya]

You need 51" inch material to do a full 48"

No, but you need at least 48.5 width, margins are limited to approx 1/4" minimum each side.

[Sign-Man Signs]

You need 51" inch material to do a full 48"

What he said. 4 sure.

[Derf]

I have 52" media

[Derf]

There has got to be a setting I'm missing!

I have 52-in Media and the printer says media size 1225mm (or 48.2283-in) but when I go to print I can only print like 47.7-in

I set the media in the production manager to 1225mm because default was 48-in..

any advice on settings I may be missing?

[Compilla]

1-Use an Unidirectional Profile
2- Make sure Flushing it is OFF.
3- Make sure under Rip&Print the position it is set to .000 &.000


Good Luck!

[PURVEYOR]

i thought the maximum media width was 50" on the 1204? didn't know you could put 52" in it.

[ProWraps]

holy old thread batman.

well, i had one so ill bite. with a chainsaw you can put 60" in it. but it will still only print about 46.5".