Cutter Upgrade / Edge ? [Archive]

View Full Version : Cutter Upgrade / Edge ?

markz

01-20-2005, 09:13 AM

we are looking to produce Edge type work, currently were a hand paint/ vinyl shop. What would be the best way to one upgrade our cutter,to work the edge ,and when finances & a deal comes along get the edge & software to complete the transition-hopefully,right?

thanks upfront !

Fred Weiss

01-20-2005, 09:20 AM

The recommended cutter for Edge output is the Envision 375. What are you using now and what kind of upgrade are you thinking of?

01-20-2005, 10:21 AM

I agree with Fred. There are other plotters that can be used with the Edge, but the EnVision 375 is the best route to go by far.

markz

01-23-2005, 10:29 AM

thanks for the advice. The package deals are little high,were "allergic" to financing-being a Reservist,things "may" change as you know. We have an xp,ready to use.the old system cutter is Aries-it's been ok for about 9 years, and an ioline. We need to eventually provide edge type work. What's a good place to start looking for the Envision, just went to the SignWorld in Atlantic City. hope we didn't miss adeal there.
thankz again Mark Z