Pc600

[Blazingsun]

Hello all,
Any one use or have used the roland PC600 printer Cutter? Ive been think about buying one.. I know they are no longer made..Ive been looking at getting one used.. Any tips or comments about them would be greatful Thanks..

:Coffee:

[Fred Weiss]

Beautiful output when they're running right but lots of reported problems with stitching and banding. Prints on pretty much any regular vinyl.

Foil ribbons only cover about 6 square feet before they run out. Limited selection of spot colors. Next to the Fargo, the most expensive way to image on vinyl that I know of. Typical square foot costs to produce are higher than a lot of Mimaki and Roland inkjet shops are selling their prints for.

Conclusion:

Very good for small stuff like labels, small decals, hardhat size where cost isn't as large a factor. The larger you go, the more everyone you compete with will be quoting lower than you will be able to go.

[Blazingsun]

Thanks for the Info Fred, I new about their High cost to produce prints, I was just looking to get some comments on the qualty of the prints.. and the printer its self didn't know there was stitching and banding problems with them.