PDA

View Full Version : Sharing a Summa D140 between two computers

Lobo
04-22-2009, 10:00 AM
I'd like to know if it's possible to share a Summa D140, connected to USB, between two computers.

/Toby
Pro Image
04-22-2009, 10:11 AM
Do they make USB y-cables...........?
Lobo
04-22-2009, 10:15 AM
Do they make USB y-cables...........?

I doubt it.

I thought that it would show up as a printer in Windows, so that I just could share it over the network, but it seems to work differently.
Lobo
04-23-2009, 03:12 AM
I got a document from Summa. Seems like I have to get a printer server and hook it up to the network to be able to use it from two computers.
Sign-Man Signs
04-23-2009, 05:02 AM
This what we use.

http://www.cyberguys.com/product-details/?productid=167
Lobo
04-23-2009, 05:16 AM
This what we use.

http://www.cyberguys.com/product-details/?productid=167

That solution would work, but then you have to make sure the switch is correct every time you want to cut something, and my boss isn't the kind of person who wants to do that. ;)
AKWD
04-23-2009, 09:19 AM
There are automatic USB switches out there, but they can be absolute monsters when they want to, especially anything with bidirection communications -- Usually don't work properly or causes havoc. And whatever you do, DON'T send two jobs at once. LOL.

As mentioned above, just get a third cheap system that can run the software properly, and then either set it up to recieve remote print jobs (Print networking/whatever), or set it up to use Remote Desktop.
Lobo
04-23-2009, 09:37 AM
I ordered a printer server that takes the USB and sends it out on the network. I think it will work fine.
Gene@mpls
04-23-2009, 01:05 PM
I assume that the 3 computers are using different plot software? Easy to do
with Flexi- I use 3 plotters from 6 computers.
II Jake
09-08-2009, 08:32 AM
I am trying to accomplish a similar feat. I have one computer that runs Onyx and has CutServer, then another across the shop that shop that runs Summa WinPlot (also where our Gerber plotter is). Right now we Disconnect the Summa USB cable from the Gerber computer and move it to the Onyx computer when I have a contour cut print job.

Did anyone get a networked Summa to work? Or is there a way to send the CutServer info to the Summa over the network to the Gerber computer and just leave it hooked up over there?

Thanks!

(I am using a Summa s160t... but I don't think that would affect the conversation much...)