software

[arcobaleno]

Does anyone have an idea what I can use as software to operate my Graphtec FC-4200-60 PLOTTER & cutter, that can tackle the cutting and creasing at the same time. The plotter has two pens attached to it. Pen 1 and pen 2.

Any Ideas. Thanks in advance.

[Checkers]

Where's howard when you need him :)
From what I quickly glanced at the graphtec website, you can control the pressure of the pen/blade to accomodate both cutting and creasing. So, I would guess that it would really depend on the drivers, which are available here:
http://www.graphtecusa.com/products.php?cat_id=1&visit=img&series_id=4&view=D
From there, perhaps, you can set up a 2 layer file in Corel? One for the crease and one for the cut.

Checkers

[arcobaleno]

Thank you Checkers, I will try that.