How to install Roland Camm-1 GX-24

[colorgreen]

I would like to know how to install my Roland Camm-1 GX-24 without a CD I am operating windows XP

[2NinerNiner2]

Bonjour de Montréal, 'colorgreen' :) ... notice that this is your first post so welcome to the board :)

As for your question, go to Roland's site, download and install the GX-24 driver for WinXP and away you go. I see you have Corel so you can cut directly from there; I'm not familiar with the others but I would expect them to work as well.

http://www.rolanddga.com/support/
Step 1: select 'Current Products'
Step 2: bottom of the page, select 'Vinyl Cutters' and choose 'GX-24'
Step 3: select 'GX-24 Windows 2000 / XP Cutter Driver'

[TC49010]

:Welcome: to :signs101:

[colorgreen]

Thanks for the welcome sounds like a pretty cool place to be.

[Cadmn]

howdy from Texas:Welcome: 2 :signs101: you will find cutting from corel is set as printing the downloaded drivers should load it correctly & go into corel print pick your cutter & away u go make sure NO fill & lines are set to .001 thick/hairline hope this helps

[Ian Stewart-Koster]

Niner, I'd been warned to avoid the Roland DGA site, and to get the drivers from Roland DG site. The files were not as temperamental or corrupted, I understand.

[2NinerNiner2]

Ian - hadn't heard about that one; the ones that I downloaded and installed seemed to work OK, but that's good to know though :)

[Ian Stewart-Koster]

Maybe it's only some drivers, and maybe there's some luck too!
I think the dg site is from Japan & the dga is from USA and the Jap's one was supposed to be the better- that's from a few people on another forum who've been plagued with difficulties using dga drivers.

edited to add: http://www.rolanddg.com/

[Cadmn]

Ian you are correct on location Roland dga is American. As of yet I have had no problems with drivers from A