"2D" routing with a ZUND

[RoCo]

Looking for some guidance as far as routing (or "carving") out areas to create raised letters or logos instead of just following along vectors and cutting out shapes. My call to Zund support has yet to be answered. Any help from the board?

THX!

[jhilldesigns]

its called "island fill" in my proprietary toolpath program (not a zund or anything, but it may help you find the command)

[rfulford]

This is a function of the software not the machine. I do not think this is supported in icut. What software are you using? You may have to try a program like enroute.

[RoCo]

The software I use is called "Touch & Cut" which is Zund's own software. We haven't seen anything in it to indicate what we're trying to do, though. It also didn't come with an instruction manual for the software, either, so it tends to be a fair amount of research, trial-and-error and question-asking to achieve a goal.