Where to buy Mimaki blades?

[Jesse_gvi]

Does anyone know where I could get blades for the Mimaki FX series of cutting plotters that aren't "General Vinyl" blades? The one that came with the plotter lasted a lot longer and was better for fine-cutting than the ones from the factory via Advantage.

[myronb]

try www.havels.com

[cleancutblade]

I guess I know where you can find them and get a 25% discount too. Are looking for the "combo" blade? :Cool 2:

[Jesse_gvi]

What is the combo blade? On our old Graphtec, we used a blade that had a more acute angle to it than the "General Vinyl Blade" from Mimaki. The problem is that the serifs on smaller letters stick straight up after they are cut.

[cleancutblade]

The combo blade is a cross between the General blade and the small character blade (50° offset .005). The angle is higher (50°) but the cutting edge is longer because it has the same offset as the general purpose blade (37° offset .0012)

[WVB]

I highly recommend clean cut blades!

[Jesse_gvi]

I purchased the combo blades and they seem to be the solution to my problem. The factory blades seem to get exponentially duller at the beginning and then stay dull for a while until they just go bad. I put in these new blades from Clean Cut Blade a while ago and they're still sharp. I'm not having the problem with the serifs sticking up either. I would recommend these blades to any who are tired of continually changing the factory blades.