SandMask

[signage]

I would like to know if the enVision 375 can cut sandblast Mask .35Mil thick? Would this be hard on the plotter? What plotters are best for cutting this?

TIA
Brian

[Checkers]

Hiya Brian,
Gerber's equipment is very good, so I don't see any reason why the plotter can't cut sandblast mask. Just be sure to use the 45° or, ideally 60° blade. No pun intended, but the 30° won't cut it :)
I've used the older Gerber 15" plotters to cut just about everything. I prefer the reliability of a sprocket fed plotter when it comes to cutting sandblast mask and reflective materials.

Checkers