Results 1 to 2 of 2
  1. #1
    College Sophomore
    Join Date
    May 2008
    Location
    Slovenia
    Posts
    228
    Post Thanks / Like

    Stoneguard vinyl

    Hello!

    Im about to wrap hood with Oracal 270 stoneguard. And i would like to know, how do you finish the edges? Do you cut it at the edge, or do you band it under the hood?

    Im affraid, that if i cut on edge, it may came off in a while...



    and how do you combine 2 pieces if hood is too wide?

  2. #2
    Merchant Member
    Join Date
    Dec 2010
    Location
    Ga
    Posts
    39
    Post Thanks / Like
    ORAGUARD 270 is intended for flat or slightly curved surfaces. The thickness(6mil) and the films’ characteristics will not successfully conform and hold around the edges of body panels. Ideally paint protection films are pre-cut from custom patterns specific to your vehicle that will stop at or before the edges of a panel. Paint protection film is not intended to be overlapped and traditionally for esthetic reasons is not done in multiple pieces per body panel. ORAGUARD 270 is available in widths up to 50" and ORAGUARD 280 is available in 60" rolls, which is wide enough for nearly any hood.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

 


» Search for Fonts at Signs 101


Looking for fonts? We highly recommend MyFonts.com

MyFonts

Powered by vBadvanced CMPS v4.3.0