I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I want to express my whole hearted thanks to Solventinkjet for your advice! You were spot on with everything! I was just about ready to turn this thing into a boat anchor! Now, it's printing as good, or better than it did when it was new! I'm going to put it back together over the weekend, and...
Thanks for responding. I changed out the dampers and the maintenance station today, and unfortunately it did not solve the problem, and has actually made it worse in my opinion. Now the black prints about a half inch, and the other colors start fading out at about 3 inches. The head cleans and...
Thanks for your response! I am just about at my wits end. I changed out the dampers last night, and today things are worse. the same thing is happening, only now I only get about a foot of black. I just ordered a maintenance station in the hope that will cure the problem. I'm sure open to...
I can do a normal clean followed by a perfect nozzle check on my 1324x. Then I can print a solid black for about 2ft and the black fades to a dull green. I repeat the nozzle check, and have a perfect CMY, but no black. A head clean then gives me another perfect CMYK. Rinse and Repeat. Same thing...
I can do a normal clean followed by a perfect nozzle check on my 1324x. Then I can print a solid black for about 2ft and the black fades to a dull green. I repeat the nozzle check, and have a perfect CMY, but no black. A head clean then gives me another perfect CMYK. Rinse and Repeat. Same thing...
Mutoh VJ1204 had an error of e087, changed printhead and cables, had mainboard tested (it's fine) now what?? Is there anything on the CR-Board that would cause this?
I have a Mutoh 1204 and keep getting a e087 error, replaced fuse on main board, replaced head cables and printhead.... Still same error... Any other ideas other than the trash can??
I recently had to replace the manifold adapter on my Mutoh 1204. Broke a damper nozzle while changing dampers. We did a complete flushing of the printhead, and everything seemed to be fine. We also replaced the maint. station (genuine Mutoh) and installed a new wiper. We printed with it for 3...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.