I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Thanks nsm. I’ll certainly try the down cut as I know our bits are up cut. It’s chewing the edges up after a certain amount of cutting and though it isn’t lifting, it’s like the bit gets hot and just melts the aluminum to the bit. We have had to slow it down to like 25-30 in/min and that is...
Has anyone in here figured out the secret for cutting 040 aluminum in a sharp cut Colex router?
We have tried and tried to cut this and wasted over $200 in bits trying everything. Went to the manufacturer site for the bits and ran with the proper speeds, rpm etc and just eats the aluminum up...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.