• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

versaworks 5.5

  1. versaworks 5.5 needed

    Hard drive crash and the ghost drive I had done up doesn't have Versaworks 5.5 on it. I have found a couple of links but they either fail or ask for a password. Searched the forum here and I am not getting anywhere. Hoping someone can help. I have the XC-540 and I can't use the ver 6 that Roland...
  2. Suggestions SP-300V/Versaworks 5.5.1 Perforated cut No Force increase

    Hi All, My first test I used 70-micron Vinyl. Using a 60° blade, I have adjusted the blade depth, scored 2 cuts of vinyl layered over each other making sure the top layer cuts through, bottom is scored. The machine pressure is set was set at 45gf. I have adjusted the pressure for normal cuts...
  3. Need Help SP-300V Perforated Cut - No Pressure Increase

    Hi All, Playing with the settings for perf cut contour. My first test I used 70-micron Vinyl. Using a 60° blade, I have adjusted the blade depth, scored 2 cuts of vinyl layered over each other making sure the top layer cuts, bottom is scored. The machine pressure is set was set at 45gf. I...
  4. Illustrator vs versaworks 5.5 cut marks

    Hola a tod@s!! ¿Cómo puedo poner las marcas de corte en el documento de Illustrator, pasarlo por la fotocopiadora y hacer que versaworks 5.5 las acepte?
  5. Roland VW 5.5.1 length limit

    Printing banners today and I can print a 15ft banner fine but a 17ft banner just prints the trim marks and advances all the material out. I stop and deleted that and reduced the banner to 15ft and it prints fine. Does VW limit the length of banner you can print and if so can I change that?
Top