Recent content by absoluteinkuk

That’s awesome man! Mines a bit different. I’ve had the tattoo studio for 15 plus years and about 8 years ago started dabbling with cutters did some wall art and basic stuff then progressed onto commercial signage mainly shopfront signs and window graphics. Usually would outsorce the latex...

That’s awesome man! Mines a bit different. I’ve had the tattoo studio for 15 plus years and about 8 years ago started dabbling with cutters did some wall art and basic stuff then progressed onto commercial signage mainly shopfront signs and window graphics. Usually would outsorce the latex...

Nice one. What printer you got bro?

I am in Coventry mate. You?

Hey guys Progress today! See the YouTube link below. Terry I moved the top point down to around 50. The print is good enough for now I think it’s as good as it gets. The test image print was ok, could maybe do a little bit more vibrancy but I am happy how it is. Thanks for all the help

Awesome! I have found that image in full resolution. At https://www.lapseoftheshutter.com/printer-test-image/

That’s perfect thanks again man! I feel like there is light at the end of the tunnel. Only issue left is when I load a media roll the carriage moves to measure it I guess but it goes past where it is and thinks it’s wider than what’s actually there.

Oh thanks man I just saw your post after my reply. I will give it ago again tomorrow when I am back in my shop. I will try and find that image. Thank you so much for all your help

Ok mate thank you. So if I drag that down what should the input and output be set at what values? On the picture I posted I had input at 50% and output at 25%

Ok mate thank you. So if I drag that down what should the input and output be set at what values?

Hi Terri definitely some progress made. I made output to 45 and then kept going lower to get the pictures lighter the top left pic is at 25% output. The rest were 35-45%. Do you think I am on the right path? Here is what my settings look like too all the input is around 50% is this correct?

Thank you :)

Thx man. I will give it a go today.

Here we go

Here you go mate. On one pic you can see settings. On other how pic should look and also what’s being printed.