Recent content by Aedwards01

I have thought about this a-lot as well. In my experience at one shop I worked at we mostly used the Roland to print and cut are decals and heat vinyl transfers. Especial if we laminated the decals because it seemed to take more time and patients to try to set it up on the Graphtec. I was always...

Thanks everyone! I think we are going the route of getting a tech.

We did do this test a couple times. I just ran it again to see what it was like today. Here is a picture of the out come. Looks like I could move over to -6 .

hmm yea that what I was wondering. The bad thing is I'm only here two days a week to help work on it so I'm worried it also might be a problem that its not run enough. Here is a test print I just did and the cyan looks rougher then it did the last time we test printed.

Hello Everyone, I am new to the page but found it when looking for answers to why are printer is printing the colors offset like the pictures below. I haven't run in to this problem with my past Roland experience till now as I just started working at a new Maker Space. It seems like they have...