I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Ok I will do this, now that you mention this the machine would occasionally trip the fuse board with the RCD (Not sure how fuse boards are wired overseas but in Ireland we have an RCD which only trips when there is an earth leak) I just got the electrician out to remove the RCD. However there...
All things points to the lead screws I think. I'd have a go fitting them myself if I could get them? Any idea where to buy them? People have also mentioned encoders and electrics for the issue however looking at these screws I should probably replace them because they will be probably need...
Hi Guys, thanks for the replys. I just got under the machine and would say the black is coming off across the full y lead screw like the image. Does this mean it's worn? X looks similar too.
Hi Guys, I just bought a second hand 408 and I'm noticing now it's not accurate. Approx 1mm in x axis and1.5 in y axis. So a 200x200 square becomes 201x201.5. I can cheat this a bit with the cutter but the circles are very bad. Has flats sections on top and bottom and fatter on the sides. It...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.