Recent content by andrzejw98

Well, we might try that. I was thinking either that or replace the whole wiring loom (we parted out the second printer and have a whole box of electronics, but already tried most of those).

Hi everybody. Unfortunately I have to ask once again for your advice and insight. The printer is STILL having the error, so we kept on swapping parts for known working ones. To sum up, it still continues to throw the E084 error while printing. Things that DID NOT help: 1) replace motherboard...

Keeping this thread alive because not entirely sure if it's fixed or not. We replaced the motherboard with the one taken out of older printer. It printed like 3x 50 meters without a problem, today it crashed once, it's printing again ok. By the way, does anyone have an idea how to store a used...

Wow, I haven't posted for a little while as the problem seemed to fix itself and then the holidays came. Spoiler alert: it didn't :) Yesterday the printer threw the error code after printing like 20 or 25 meters of narrow paper. I checked my marks on the belt - it didn't skip a single tooth. The...

Thanks, I would appreciate that. Are these motors for CR same as for PF? I didn't measure the CR motors yet but will if I don't find another solution. Yesterday it kept popping up on fast prints. Then I run some more as fast as I could to test and couldn't get it to appear again. Earlier it...

I don't think it's that, it stops in the middle of paper, not when docked...

That's what I thought as well since it says so in the service manual, but went with the PF motor idea anyway because of no success with CR motor. Well now that I think of it, can certainly happen and does happen. Coincidentally, I bumped my finger into the moving carriage like 3 minutes ago...

Sooo, looks like all the bearings are rolling freely (rollers, bearings in the pf motor, bar bearings). We cleaned the encoder wheel. Then we swapped the pf motor from old printer. At first it looked like it fixed the problem, but actually not. Yesterday in the evening it crashed twice while...

Thanks for Your reply. I think we have cleaned the wheel already, but will do it again (it caused problems some time ago). I don't think it's a problem with static - we only print on paper and then the images are transfered to fabric. Didn't even know the vacuum setting could be changed. Will...

Hi, I’m starting this thread as I can’t find another one that fully describes my problem. It’s about the E084 Y2 current error on our Mutoh RJ-900X printer. We have two of those, one was bought around 2016 (firmware version 1.03) and the other one in 2020 (firmware version 1.06). The newer one...