Recent content by Arthur Sanchez

Does anybody have recently changed DX2 print heads they want to get rid of? I would be interested in buying for the right price. Thanks

Can you please tell me how to mix the homebrew flush? Thanks

Here is their address: Junaidsite.com JL. Jend. Sudirman Kav. 2 12920 - Jakarta Pusat Jakarta - Indonesia I have tried to order but I haven't gotten any response. I'm not sure if it's legit or a con

Does any one have 2 dx2 print heads for sale (cheap)? There is a place in Indonesia that is selling them for $115!!! Sounds to good to be true.

Anybody buy anything from Junaid Wide Format Printer Parts Store?Their dx2 are only $115!!!!!!!!!!!!!

It's a Falcon. I'm getting air from the right side. Thanks

OK here it goes. I have a Mutoh 48" ecosolvent printer. I changed the maintenance station about a year ago. It is not printing the colors on the right side of the capping station. It has new dampers the print heads are clean and I installed a new pump. It seems to pull ink on the left side but...

I have a 6 color printer & use Flexi 8. All I do is rip it using just 4 colors. I skip LM & LC. Prints great.

Reset "HOME" position to get the carriage over the CS. How do I do That?

Must I do a Print Head ranking if I just pulled the heads to clean them and put them back? How important is it to do a ranking ? What is it's purpose? I've had 2 techs say it really isn't needed. What do I do if the heads don't line up over the cs? A lot of dumb questions, But I'm sure there...

Can someone tell me: 1) How can you tell if the headprint fuses are bad. 2) What kind of fuses are they? Any special number? Voltage? Thanks

Well just talked with Sign Warehouse & they want $566 + s&h for the MS. Also called Mutoh & they said they could only give me the part # which I already knew (my-21474). Heck do Roland owners have the same support problems ? Thanks

Do any of you Mutohnians know the best place to buy a maintenance station for the Falcon 48" printer? I figure it will be easier & faster installing it than buying the parts separately. Thanks to all.

I can pull air from the waste lines but not ink. What else can I try? Thanks

No ink at all. I also mentioned that I pulled the printheads out & cleaned them. I want to know since I pulled them out if I need to rank them & how it's done for future reference. Thanks