Recent content by AUTO-FX

Nappy Christmas!!

it's still pertinent. yes, how did it go?

I once had a customer with a fleet of corrogated 50 ft trailers, and they refused sign panels. I would run a tape line to follow, and just go with the peaks and valleys. The only stretching was to keep it following the tape line,witch I always did approaching the peak, and a little in the very...

I'm not expecting many will even remember me,since it's been awhile, but just thought I'd come back here and say hello, and Merry CHRISTmas and stuff. I missed everyone here, and all the drama! TTYL !

Welcome to the show!

agreed

Hot Plates in Holliston Mass

I subbed out job a while back, and I think I used Stouse. Signwarehouse sells a lot of alum blanks. I found better place to buy them , and I cant remember who. They were in Mass I think. I'll see If I can pull the last invoice.

Ok, thats easy to explain, and there are settings in production mgr. I assuming youre saying that somtimes you can hit cu t and It justs gos and other times you have to go into PM and hit send job. When you hit print, PM either starts up, like a second program opening, or it has already been...

Wait, what do ya mean it "skips " production mgr? If the job is on your design screen, and you hit print or cut, PM is the engine driving your device. It cant skip it. ....and welcome to the forum...

How bout a putting green on the roof?

Thanks for the tips, I like the dimming trick! Heres a couple pics of the finished product. My buddy is thrilled! ( note the size of the rear tires on that baby! Tubbed to the max! )

Wow, that's AWEsome! Hope you dont have to take it down. That would be ridiculous if they sent you a cease and desist.

Well, what about Mactac Roughwrap? Mactac stuff is great! Ask Chris @ GRS

Uhhhmmm, what brand are they again??