Recent content by B13 Signs

yeah, I already have a printable refelctive that I use, but as Manuel said the reflecive doesnt show great threw dark ink. so printing wont work. Also I have already done 3 trucks two years ago and they want them to match... so I am a little stuck right now and upgradeing to the 3M doesnt get me...

Yeah, the cost of the 3m is triple the Avery and the reflection is white were the avery is light golden... So its a different look...has anyone successfully installed Avery on conture without brusing? Or do i need to just bite the bullet and upgrade?

Hello, I have been doing a few jobs for aPolice department and have put black refelctive(avery4090) chevrons on the rear tailgate with little problems. but the new 2025 ford tailgate has a tricky body line that causes me to need heat for install. The materal really cant do much heat or any at...

I have had a similar problem before; and what i had done is, either clean or change out the encoder strip 'encoder scale'. That is the thin plasic strip with vertical lines, just below the timing belt. Dust and splashed ink can cause it sensor to read wrong. I have bought and changed it on my...

Thanks, i did some digging from your suggestions and found something that will work... I think it is custom

I own the same printer and had a similar problem a few years back. i had a head strike and was cleaning the head with a syringe. In the process of taking the dampers on and off there was a small tare in the pastic of the damper. i couldnt see it and the ink wasnt leaking; but when i pulled ink...

I know I havve seen the font but I been through my list and cant find it

THANK YOU!

Looking for this Brushed font to recreate this logo

I believe that the cut contour and other metallic color are a different swatch than the Roland color system folder. To gain access to the swatches you go through your art program swatches not through versa works. ie Illustrator...

Hello, I just purchased a Roland XC-540 used and I have been running a Roland SC-545EX for years so I am familiar with the Roland printers. I am running into a lot of issues with registration marks and alignment... some time it reads the marks no problem but cuts off as it feeds out; even after...

thank you

thank you

Need an ID on this font have found similar fonts but its the "G" that i am stuck on, also some numbers greatly appreciate any help Thank you

Looking for an ID on this font I have found a few close fonts but I need the right one. Really the "G" is what I cant seem to match... any help would be greatly appreciated. Thank you