• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Barry Davis

  1. Can anyone recommend a "VERY HIGH TACK" Transfer tape?

    Try wiping down the vinyl with rubbing alcohol before cutting. This works for us.

  2. CAMM-1 PNC-1000 illegal Pinchroll Position

    Today it seems that all I have to do is to turn the plotter on and off a few times and it will work properly. Without moving either pinchroller, this looks like it is a firmware problem in the plotter. It could still be a bad connection,

  3. CAMM-1 PNC-1000 illegal Pinchroll Position

    20"

  4. CAMM-1 PNC-1000 illegal Pinchroll Position

    I have owned this Roland CAMM-1 since the mid 80's. We only use it for cutting tiny lettering, so it probably only has about 40 hours on it total. I have never had a problem...until now. About 4 times out of 5, I get an error message "Illegal Pinchroll Position". It looks like the sensor is on...
See more
Top