Recent content by benski

Well that makes sense. Yes, the little battery. It is very old and spent bit of time in cold climate/garage. Appreciate the response!!

Hello I started getting error E067 err X encoder. Error appeared immediately on start up. Could not bypass it either in diagnostic or maintenance mode either. I replaced the PF motor and the sensor, cleaned the PF disc and still error persists. I had a spare main board around so I installed it...

thanks I finally got some parts I did. they did not have what I was looking for. But found a store out of Miami I believe was able to help me.

thanks I have finally located some parts.

Makes sense. I'm still trying to figure all this out. I started at 220 F and now I'm at 265 F temp. At times it comes out evenly melted and looks clean other times it is less cured, more bumpy but if I go any higher on temp I get more yellowing or burning. Film looks over exposed.

turns out we just need to make sure it's completely cool to peel.

Alright. Most likely will have to check the powder then. With a complete cool we are able to remove and finish the work. With our third party films 10-15 secs was enough to remove the film. With our current set up, the film we peel all off when all garments are complete and its working out ok...

I did my first Dtf print and press. I've done alot of DTF presses and it has been pretty easy going. With third party films. Mine are not working out so good. Having a tough time removing the film without lifting the print. tried pre pressing the garment, med-high pressure, 140,150, 160 deg C...

company is called Topuv. They were helping. But most videos including them just said to create W1,2,3,4 channels for the white. I didn't capitalize the W

Upper case W in W1 is my answer. The little details. Came across a new video where buddy says it.

What am I missing! I’m comparing the 2 files and I cannot spot any difference. W1-W4 are the last 4 spot channels. I have found several YouTube videos and it’s so straight forward. I’ll keep beating myself , thanks hopefully something obvious pops up here.

Im very new and only had my printer for a week. I’ve spent the entire week trying to get it to print the white on top or last layer. No luck. Open my file in PS> cmyk>300 dpi> remove background>select with wand and inverse>select modify and constrict> 2 pixels. New spot channel W1>duplicate...

Im using kraft paper. All my presses are on a 40 by 30 inch press. Is it possible to find parchemtn paper of that size?

hi it is a clamshell. Ive pressed the same way for 10+ years with no issue. Changed the press to a manual with no breathing holes on the bottom platform. I think you are correct. Now that I have no breathing holes its shrinking much more especially the brown paper. paper looks alot more beat up...

Ive changed my press only. been pressing this way for 10+ years. My press drawer or platform does not have holes at the bottom. As if its not allowing the bottom to breathe or move air.