Recent content by BrentNaquin

I think I may have resolved this issue by changing from a calendared print profile in vertelith, to a cast profile. Only with the help of Scott! Thanks Scott. I will update if issue continues...

We recently printed a large red wrap for a commercial client, the entire print had banding spaced evenly apart. As you can see above the issue is still occurring while printing large color panels. It appears to only happen along the edges of the vinyl. I recently have cleaned the head manually...

Bump! Does anyone have any better advice? I got the gradient good, but the red has lines. I cleaned and aligned printer head. did full weekly maintenance. No change. I recently switched over computers. This may be the cause. However, a higher up from Fellers support virtually set up most of the...

I never thought of multiply with white and black. That’s good brother. Thank you. I will try that as well. When I get back to the station tomorrow I will check alignment and motor speed. I just did a paper feed adjustment.

Hello everyone at the shop I work at I am using a Mutoh xpertjet 1641 SR pro, vertelith, and illustrator to create the gradient in PDF. Just to give background, I have attempted to print red fade to black gradient before and have not had success. The only solution I found to work was to print...

Hello, my name is Brent. I appreciate any feedback or help with this issue. Print was fine and dried overnight, laminate looked good before lamination. Once laminated I noticed these lines in the finish. Has anyone seen this?