• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by CORsigns

  1. Roland GR2-540 cutting prior to prefeed

    I'm running a Roland GR2-540 cutter and outputting from Flexi 24. There are times when the plotter will start to cut a small portion of the job, then prefeed, then pick back up and finish cutting. I can't for the life of me figure out why. Any suggestions?
  2.

    Mimaki JFX200-2513 Height Check System Halt(2) 441:Headheight Wrong

    A photo would be fantastic! I'll watch for it. Thanks so much!
  3.

    Mimaki JFX200-2513 Height Check System Halt(2) 441:Headheight Wrong

    You removed the carriage cover?
  4.

    Mimaki JFX200-2513 Height Check System Halt(2) 441:Headheight Wrong

    Same here. I cannot seem to figure out where the head sensor is located.
See more
Top