Recent content by cyclerc

Use the color correction in rasterlink, create a color with cmyk outputs . Is a very useful tool , the colors looks better and consistent. I use for my red ,orange and flo yellow.

After one night without print the first test print is almost full,but after first print like 30x48, the next test print the orange print half. new cap,new damper,ink pulled from line,new ink cartridge all oem.

thanks! the cap is brandnew oem

Any Idea? test print samples, most complete is as soon turn on the machine the other is after 15 min print. another new cap was installed.

Im the only using the printer, never head strike, looks like cap is not parallel with the head, after a soft clean orange ink is present outside the cap. I tried the capping adjusment in service mode but nothing change, can be do some alignment with allen bolts?

Yes! The problem comes before parts changed, no flush line yet. Recommend to do in the end of the damper top ? Remove the line there and pull solvent true the line?

ALL PARTS OEM AND INKS OEM

Can't find the problem , any sugestions?

I will check more deep. No any visible leak

Having problem with orange, new cap,new damper, miltiples soak, clean etc. the missing nozzles, sometimes come back but after print loose like half. Here some print test before print and after short 30" print. Any ideas?

Mimaki jv 150 How often the wiper have to move to printhead during printing?

GO SIGN DON'T RECOGNIZE, only works with wifi and sometimes dont work.

the plotter show in the display usb1 but the gosign dont recognize usb plotter, only work with wifi/ip the same in 2 different computers.

usb port in plotter

thanks for quick reply, the drivers are installed, I always use the ethernet but sometimes disconnect and I have to turn off/on the plotter to find in gosign, would like to connect usb for this