• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by DaveD

  1.

    Masking tape recommendations

    Masking tape is one of those expenses that we just can't get around. We use magnets any chance we get but they don't stick to aluminum truck bodies and fiberglass boats unless you tape them on! To the point, we've been using 3m automotive refinish 388N for years, however, they price keeps...

  2. Die cutting on FC9000

    Do you have a step by step guide to do this?

  3. Boat club flags and burgees, supplier recommendations

    I'm in need of a supplier that can produce flags and burgees. TIA

  4. Edge printing white on clear static cling

    Clean everything twice before you send it! Stupid dust bunnies!

  5. WTB Gerber Edge Setup and/or foils

    I have some unopened foils that we will not be using. They are for the older style of edge. I'd have to make a list of what we have.
  6. DaveD

    Thankyou for the tips.

    Thankyou for the tips.
    • DaveD
    • Profile post comment
  7. DaveD

    Hi troy, The flatbed is being used about every other day. We are still running the three roll...

    Hi troy, The flatbed is being used about every other day. We are still running the three roll to roll printers non stop. We haven't made a large enough shift or addition to the direct print industry to justify the new flatbed. I need to tap into some leads that will boost that section of our...
    • DaveD
    • Profile post comment

  8. Will an Epson S80600 fit through a standard interior door width?

    I had to take off the take-up real and a couple brackets on the heater unit on ours to fit.

  9. Opinion Need A New Heat Gun

    We buy these 6 at a time and always try to keep two on the shelf in the box. We get about 6 months of hard use out of them.

  10. 8' Table Throw today

    Can anyone produce and ship an 8' table throw today or tomorrow? I'll need it in hand in Washington State by Thursday.

  11. Advice with stocking router bits

    What do you have for a V groove bit?

  12. Any Freelance designers out there?

    We are having a hard time keeping up with our design workload and are in need of some help. If you're a freelance designer looking for some work please message me. Thank you!

  13. Advice with stocking router bits

    We just had our Summa F1612 standard router attachment installed. It came with one multipurpose bit (500-9852). I'm looking at Summa's "router bits overview" and I don't get a a lot of detail and guidance as to what bits I should have in stock. I'm not opposed to using other brands but as a...
  14.

    3m TSA-4 or YelloTool Wall Roller

    I like the look of that tool. The heat gun becomes the second hand hold.
  15.

    3m TSA-4 or YelloTool Wall Roller

    I think you're right and I'm sure I'll end up getting one or the other.
See more
Top