Recent content by DavoLab

Thanks, I have not been able to successfully play on the machine due to work volumen, I tried and it game me an error regarding permissions, so I need to look into it.

It stopped working out of nowhere, windows 11 machine. It happens only with one of my 3 printers on the program. I did deleted the printer added back again and still no luck. Any help will be greatly appreciate it

Hey Fellas, Im having this issue when printing, it starts fine and suddenly after 70cm it starts to band. it happens with both 6 & 8 pass bidirectional. It happens as well with more colors not only magenta. I have brand new (1 month heads), test print is perfect and both pressures as well. The...

Thanks for the advice apparently is a rasterlink limitation over 50ft, i was able to tile them up with two 30ft piezes until i found out the reason. I apologize for my ignorance what do you mean by turn off AA

Thanks, I actually have the key for 7 as well since one of the machines came with it, i was unaware that they could coexist which will make the transition way easier. I'll give it a try

Now that would make a lot of sense, even though it didnt let me load the 50ft I'll try tomorrow i with 598 inches and one with 601 and see. If thats the case maybe using rasterlink 7 could be a solution. Thank you for helping me and I'll make sure to update

Thanks for the tip, I've check and Ram and Storage are perfect. Funny thing is i tried segmenting the file to 30,40 and 50 ft. The 30FT and 40FT read fine, but 50 and above it just wont load and get stuck at 0%. Which it doesnt make sense to have 100ft roll and wont be able to use it.

Do you use any other software in between? i had the same issue same machine, i use a mutoh for cutting and when i register the marks and export them it was causing the issue, eventually it was my exporting software

Basically, I'm looking to print a 60 by 10 ft print, however the file wont be read by the program, it is worth noting is my first time printing anything larger than 25ft but it shouldn't be an issue. File in question is a jpeg, get stuck after opening on rasterlink in reading status at 0%. Tried...

My apologies for my ignorance, how do I check ( i do believe within the menus) but the question is more about how to update it. Thanks

Thank you, the printer is definitely not the mistake, I have a router for foam board and it does have marks similar to the mutoh and no issues. I'll do the 2 feet mark next, let me ask you why does not allow me to setup the material to anything larger than 52" on the width side. Thank you again

First post and I'm ready asking for help lol, Here is the issue, i use the software flexistarter shipped with the machine, I am able to create the outline and marking lines to print and cut without issue, the problem is when the print is over 4 feet, the upper marks cannot be read, like the...