Recent content by Dennis Schaub

Do you recognize this font? It is from a John Deere skid steer. Thanks!

I am installing some signs from Howard Industries, direct burial. They have the "bent-over" posts, and I am wondering, how do I install them without them falling over? I am not sure if the concrete will hold them in place until it dries or if they would require temporary bracing, or? Has...

Are you stocking up on any inventory before any potential tariffs take effect? I have been debating stocking up on some things, not sure what all might be affected.

I have had good luck with Wall Dogs

By hand

I am getting ready to overlay some 4'x8' prints with Aslon Clear Dry Erase vinyl. We have done this before and struggled with installing it without bubbles. We also have issues with the edges wanting to lift up. Any advice would be greatly appreciated! Thanks

I have a customer who would like two eps monument signs, so i am looking for a supplier. Thanks!

There it is!

No, similar, but this one is 58 pages long. "Sign Legibility - The impact of color and illumination"

It is a printed catalog. I doubt it is on the open internet.

Sorry, I should have been more clear. I am not looking for a "letter height" recommendation, but more the amount of information that is reasonable on a sign. I found the article I was referring to, it was in an old USSC book entitles sign legibility.

We typically encourage customers to keep the number of words on signs along roadways under 5. I once read that every word over that decreases readability significantly. But I can't remember where I read it now. I would love to actually not the actual source to customers. Has anyone else read...

Yup, we have sent two to the Plotter Doctor for service and they did good work, just trying to avoid shipping these giants across the continent.

I have three gerber plotters and an EdgeFX. I would love to have someone come give them some TLC and give my wife and I some training on operation. I have been using them for 20 years, but recently running into all kinds of problems. Currently struggling with back cutting vinyl. Does anyone...

We have this conversation every week at our shop. Everything used to be so much easier. I have to go watch a YouTube video every time I want to do something in Illustrator. And as soon as you learn something, it updates and it is different anyway. Fortunately, AI will probably put us all out...