Recent content by eahicks

To be fair, it did not appear like a link on my end....usually they are underlined or highlighted somehow. Thanks for clarifying, albeit a little abrasively.

Gee thanks... I didn't think of that. That's what I'm asking for recommendations of. A product name or brand that someone has experience with.

What banner material? Looks like mega-plasticizer migration. Clean a big chunk of the banner with ISO, then run a print again and see if it continues.

LOL... I have a couple 360s I'm ready to do the same with....

We strictly use 3M 233 green 2".

Does anyone have a recommendation for a VHB or similar tape, that will hold up small PVC signs, but will cleanly remove later with no damage to paint, drywall, etc.? Trying not to use 3M Command Strips, as some of these are very small, and we have a LOT of signs to put up, and just don't want...

Bahnschrift... looks nice for print... don't try to plot it though.

Does anyone else have this issue on their 360? I constantly get the message to clean and lubricate the carriage rod when I load up a new roll to print. I just did it one day last week, and it popped up again today. This machine (we have 2) is the only one I have seen do this. It drives me nuts...

3M Command Strips. They remove cleanly and the letters will be usable if removed and relocated later.

Mechanical fasteners > adhesive. Always.

Requests for metallic/holo/specialty decals get sent to Stouse.

If you can get a refurbed 560 I'd get that. Much improvement, easier to load/unload. Same heads/inks.

Paint? Nah. I would rather lay one layer of vinyl over the back of a panel than try to get a consistent paint spray.

LOL....Commercial Script and Times New Roman.

I was searching for this very topic, like your suggestion. Do you think a translucent white would work enough for this application? How much light would you say the 7725 white will diffuse?