• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by EV333

  1. HP115 question

    Her profile says she has an L115 & Summa cutter so it's probably safe to assume she bought a print/cut setup which comes bundled with HP Flexi Print and Cut that includes Production Manager as the RIP. The Finishing tools, colour adjustment, labels & marks etc is setup in the PM Default Job...

  2. HP115 question

    I assume you're using Flexi, if you are, Production Manager -> Default Job Settings -> Finishing Tab -> check the Grommets box, enter the desired locations -> Print. When you stop learning, it's time to give it away :D

  3. HP115 question

    Yes I do. I use Flexi's RIP to print my punch marks. I don't need to use "templates". What I meant in relation to "lining up grommets" was, well, lining up the "grommets" on the actual grommet press. If you don't have a punch like mine and the one posted by Stacey, consider yourself lucky :) A...

  4. HP115 question

    {SNIP} I have the same one. The grommets that it shipped with were only brass plated steel and rust fairly quickly. My 390 odd are in a landfill somewhere. I purchased brass grommets and only used a handful before switching to the Banner Ups.

  5. HP115 question

    A decent grommeting machine can set you back between $300-500 plus the cost of grommets. The OP can always use "Banner Ups" Bravo Tabs to kick off his banner finishing. These are square clear tabs that can be used in corners or along the edges at desired intervals. All you need then is a...
See more
Top