Recent content by evoprinting

It doesnt work. We've tried renaiming and matching, no ryhme or reason. When we send files from Onyx, they will not pull what we have set them to.

You can make a setting within Go Produce to combine any overlapping registration or cut lines.

We used Postershop 22 for 2 years with good results. Upgraded in January. We're having so many problems with Thrive 24 it's completely ridiculous. We use Onyx RIP to send print files to our Epsons and Cut files to Go Produce. 1. Onyx was adding the random, duplicate reg marks and we couldn't...

There is indeed one additional screw to the right when looking up. It was pretty easy to take off and re-apply the clear plastic. Just ran a new job and NO HEAD STRIKES!!! Thanks again!

Awesome! Thank you very much!

Thanks for this post. Like the original post, we were having the head strike problem as well. Today, when checking the plastic cover, it just fell off. The double sided tape around the edge was kinda gooey. I cleaned the clear plastic and ready to try and reapply it. I need to clean the bottom...

We have an S40 and just started having a similar issue. We haven't had this happen so often in 3 years. I've increased the Platten Gap to the max, increased vacuum to the max, increased tension. Ive also decreaed the preheat and platten heat. All of that has helped a little but not solved the...

I did notice laminate tension was a factor for tunneling. We see it on unlaminatined stick as well. I do tie down the feed roll. I'll check the feed speed. I didn't know that was an option. Thanks!!

Sorry, I should have been more specific on not cutting well. Perhaps, I have two issues. If there is ever one of those bubbles in the media on the table (this seems to happen more often than I would like), when the knife has the plastic cap installed, it will travel over the area and still cut...

Hello everyone! We've had our 1612 for a few months. We ust started running into a problem with the plastic guide cover on the double edge knife scratching prints that are not laminated. Specifically, pop-up banner material. I've cleaned the plastic and that helps, but eventually ink will build...

We've had the S40 for about 5 years now. I would certainly buy another I highly recommend it. We use it for banners, posters and different types of adhesive vinyl.

We're in Virginia and order from Walker Supply, Grimco, NGlantz and Harbor. We've gotten great service from all especially Kent at Walker.

I find cut vinyl pricing to be one of the most difficult things to have standard pricing on. We charge material plus markup + file and machine setup + square ft cutting area + weeding and masking. The weeding is by far the biggest variable. We have three categories of weeding (basic...

Thanks for the tips and tricks. I'll give them a shot. I'm fairly certain something is wrong with the machine. Yes, I'm rusty but the problem keeps getting worse. I will look deeper into the pressures over the weekend. I don't have feeler gauges here at the moment. We square the lead edge one...

Too much roller pressure?