Recent content by foremost

Oh i see!!! I will have a dabble and let you know how i get on! Thanks :)

Sorry i am not following. The white lever is all the way down with the pinch rollers on the vinyl?

Daft question, but does the resolution make a difference? We had to have a new main board assy fitted as the last one blew (very unlucky as was right before lockdown). £1400 later and a engineer visit and back up and running but all the settings on the actual machine are defaulted to factory...

@iPrintStuff Yes we found cut on high was the best as well as its far more accurate. Even though we print on normal. Crop mark size wise is either 25mm or 35mm. All dependent on what the rasterlink plugin in recommends as we follow that. Yes when i mean short from where the actual marker...

@ Solventinkjet Photo attached, is this what you were after to see?

Thanks for your reply. Yes we always use the recommended crop mark size etc... Photo attached of the rear. The vinyl goes through perfectly straight as we set this up spot on. Just falls short of finding the rear markers by 2" - 4" every time. We done another cut run Friday, 4 files. All...

Hi All! We recently purchased a CJV30 back before Christmas. We have a Intermidate problem that has now become a permanent problem with the mark detection on the printer. We send all print and cut files from Cored Draw via RasterLink 5G. The printer is set to find the first mark with no...

Hi, We currently have an issue with our Gerber P2C that involves the cutter laser not being able to find the black markers that the printer prints for the 1% Cyan Path. With laminated vinyl we have to place black squares on the top which usually works. The past 2 - 4 months the issue has got...