Recent content by Hagerty

My company prints batches on 17 ounce vinyl material about 3-8 times a year. We have to outsource our cutting since we do not have the capability at this time, usually the company that cuts for us sets the file up for their Summa cutter. To save time for us and for the outside company, I want to...

Have a Mimaki CG 160FXII cutter, from 2013. Just started making clanking noise when doing horizontal cuts, and on rounded corner rectangles it cuts opposite corners at an angle instead of rounded. Not sure if belt issue or motor issue, no idea honestly.

Thanks, I have been cleaning it daily and it seems to keep it in check.

Thanks for the quick reply! I'm thinking about doing that. My concern is the Installer that trained us and the manual say we have to have the left edge of the media stay within the black lines on the printer(Photo's attached). Not sure if going past those will cause the printer to start printing...

we are trying to put a 15" roll of heat transfer media on our Epson 60600(Just purchased). The problem is the lift levers that are preinstalled hit a stopper that is on the bar so the two media roll holders can't get close enough together. I took the bolt out of the stopper and I can get one...

Just got a Epson SureColor 60600 and have only printed 2 full rolls of White Concept 201-HTAP-60 Matte 3.4mil High Tack Permanent adhesive. After removing the second roll and getting ready to put in the 3rd, I noticed a line of residue/adhesive? on the right side of the back heater, going from...