Recent content by Hype Visual

I don’t think so, not out of Onyx - it will only print and cut. I use the cut studio plugin for an older version of Illustrator and I do use it quite often for cutting only and it works well. It’s the print and cut I can’t get working and it’s only due to the reg mark reading issue.

Still no luck from my side.. There has to be a way surely, I’ve managed to get it to find the front marks but it feeds the sheet all the way through until it’s out trying to find the back ones

a

I don’t think my FC7000 will scan barcodes but it should see reg marks, have you got a bit of an instruction you might be able to write in terms of the workflow? And how you load/line up the media in the Graphtec so that it actually reads the first crop mark

I've got an FC7000MKII-160 and the latest Onyx, can send the cut job from Cut Server and the Graphtec does go looking for the reg marks but when looking for the first mark it's looking nowhere near where the actual reg mark is printed so doesn't even find it haha.... I'm sure it's something...

I’m about to try print and cut on mine using cutting master also.. I have tried straight out of onyx and it does go looking for registration marks but nowhere near where the actual printed marks are so fails on the first reg mark and doesn’t go any further. Could also be how I’m liking the media...

Definitely an old thread but hoping there’s still a brains trust around for the old FC7000MK2’s! I’ve acquired one and can’t get it to even look for the first reg mark in the right spot when doing print and cut.. sending the job out of Onyx, it does go to look for the first reg mark but nowhere...