Recent content by JSIGN

Interesting way to figure it out - all costs first, then add 50% ( if I interpreted that right ). Pricing is about the most interesting thing to me - I still am too cheap since we are busy all the time, work pretty efficiently yet barely have anything left after expenses ( really this is therapy...

Not anything I've studied, but experience tells me that the air flow will just be faster while pushing through the 6" exit point ( like pinching a garden hose to get water shooting out farther ) - but the overall system upgraded to an 8" fan would certainly be evacuating more air. Only...

Not super accurate - but works pretty well and easy to do - if you have a 3" core, then roughly every layer you can count should be approx. 1 foot ( based on PI )

I have SP 540 V SERIAL NO. ZS80660 that was working fine up till we stopped using it a few years ago after we replaced with the RF 640. You can buy the whole machine for $300 - we are in central NJ.

JIM'SIGNS, INC. in Avenel NJ can help 732-381-8700

We find good results printing onto metallic vinyls from GRIFF Company in Lakewood NJ 732-367-2166 with our Roland Eco Sol printer and laminating

We have cut as small as 1/4" graphics and they've worked for years - you can peel them off of course, but they have not fallen off in our experience.

HDU is tough to screw to - a slight twist too much and it crumbles away. We routinely weld up rear support frames using awning "flange" tubing which give us a lot of surface to glue ( typ. Weld-On 30 ) and then very coarse short screws ( we often use 1-1/4" Tap cons since they have the...

I agree with signhermd - we have been using the GF 226 HTR for the last year or two and the installers love it - have had no problems so far

Please be careful when wearing gloves for any type of machining etc. - the tip of a glove can get caught and pull your hand into a machine / roller /saw / etc.

Stouse -- https://www.stouse.com/ I've used them here and there* for over 30 years ( possibly over 40 years ) *I say here and there because we have been doing most screen printing in house until recently. Jim

I also have a 540V to sell for parts ( although it was working fairly well when we upgraded a few years back ) - we're in Central NJ

S&F has started doing Mutoh as well over the last few years - have only used them on our Rolands, but they were good, helpful and reasonable.

Thanks Everyone for all the help ! I will buy the Ronan Rich Gold to start with, and see how that works.

Agree, but the customer has been using paint ( many signs )