Recent content by julesk

Wow, it's cool to see inside one of these printheads. Do you have any more photos or diagrams you could share? I'm curious about the heating block and what the hot water path looks like inside the head assembly.

I just tried setting the flushing level hoping to prime the head between jobs. I set the flushing level to 1 and it printed two 1.76ml jobs then failed at maybe 1.5ml into the third job. I set the flushing level to 3 and it printed another 1.76ml job before failing like 1.5ml into a 2 ml job. I...

One other thing, in the manual I'm looking at it says I restarted the machine after going into the menu, is that sufficient to turn the circulation system back on? The tech has set it so the machine always boots into service mode. I don't see where in the menu to check whether it's enabled or not.

Hi, thanks for replying. It will discharge and refill the subtank without timing out. I just looked at the part of the service manual relating to the air system. I'd like to try the test you proposed although I think it can't be the only problem, because only head 4a is affected while head 4b...

Hello, this is my first time posting. We've had this printer since 2021. The printer is configured a PrCl YC MK WW. Recently head 4a is dropping out during jobs. If I run white maintain and immediately run a 15x18" job the white ink looks good over the whole job, but the next job will have...