Recent content by Kathy Moore

I have an older roland and due to illness and treatments I have not used it for sometime. Almost a year. I have a disc and cannot get the program to load properly. I do not know if chemo has ruined my brain or what the problem is. I load the program and do not get communication between the...

Newbie here. Guess someone is going to have to draw me a picture. I do not know what the abbreviations stand for?

What is TSI? SI?

I believe I pushed the wrong button on my Roland GX24 The screen read a 22.9 width and the length read__________ I did not understand what was being asked , I then canceled out. Sent the job again and it only printed a small portion of the file and quit. I was not able to resume or turn the...

I have all outlines set to hairline but am getting inconsistent cuts. some are clear thru the mask and others are not cutting deep enough to reach the carrier. any suggestions?

Does anyone know what this font is? I have searched and searched without any luck

This does not make sense. I have done this before. with no problem. Not sure what the problem is this time. I will call the company tomorrow. Thanks for the quick response. Kathy ''''''''''''''''''

I am operating an AllenDatagraph monument cutter and Corel software. I use the direct cut plug feature. The error message I am getting is "Plot size exceeds media height. The plot will be clipped at cutter height." I rotated the file and that did not help. The size of my file is 14"x48"...