• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Kipp

  1. affordable cast wrap vinyl

    Hi guys looking for a printable wrap vinyl, any suggestions on what to try?

  2. Edge sealer

    thank you!

  3. Edge sealer

    Hi all! been doing some boat wraps and looking to seal the graphics edges. What is a good product for that?

  4. AAS Detect Fail -Roland GR2 540

    Hi all! maybe someone on here has the fix for this!? After laminating and putting SOME sheets in my GR2 cutter it reads "AAS DETECT FAIL" and will not read the rest of the marks or cut. It always stops on the first crop mark, seems like it doesn't even attempt to read it, just moves about an...
  5.

    VALUECUT II 1800 DOES NOT READ AAS

    I have a Roland cutter and only on certain jobs it gives me AAS detect fail, how did you fix?

  6. banding

    Now it's not banding at all after I clean it, then after a print or two it starts again? Weird!!

  7. banding

    I've used the (generic vinyl) profile for the last year, it does print better on uni directional. I'm not sure how to adjust the profile, the material is 6Mil white gloss. So you don't think the head is bad? I just ordered new caps to try

  8. banding

  9. banding

    you can see in the black area what I'm talking about, I think it's that microbanding??

  10. banding

    yep, here are some tests I ran. the machine is 1 year old. I had my other Roland 15 years.

  11. banding

    I have used the same profile for the 3mil material I use and 6mil for years. Since this has happened I printed uni directional and seems to help. I'm not sure what other profile to use on the thicker material.

  12. banding

    yes I checked the simple and detailed calibration, looks dead on. The microbanding you saw is what I think is going on here. Very fine lines that almost looked indented in the print? can only see them in the right light at the right angle.

  13. banding

    I posted this in the general chit chat yesterday (sorry, I missed this forum to post) Running a Roland SG2-540 (solvent ink) But I'm getting banding in my prints (6MIL glosss) , but when I run on a thinner vinyl it's fine. (3MIL gloss) Any clue why this is happening? I manually cleaned the...

  14. banding in prints

    what did you do to fix that?

  15. banding in prints

    Thank you, I ran both tests and seems to line up well. Ran another manual cleaning and will try cleaning the encoder strip. I appreciate the help
See more
Top