Recent content by kkotvas

Its definitely been difficult to figure out why our 560 has been printing slower. I've had techs and reps out here to look at it. No matter what profile we use, no matter the media, it always prints slower than the 360. If you look at this video on my YouTube, its a great example of what I am...

I would start with one of two ways. 1.) Pull up an image into ONYX that has the kawi green in it (like the attached) and open it in the job editor. Go to the preview and size tab and hover over with the cursor so you can see the CMYK build of that color. Write down the number values and you...

Hello - I was wondering if anyone else had similar issues with their HP latex printers. 1.) SLOW PRINT SPEED We got a HP Latex 560 back in 2020 and its always printed super slow no matter the print speed. We are comparing this with our much older HP 360 which can sometimes print twice as fast...

Hello - I was wondering if anyone else had similar issues with their HP latex printers. 1.) SLOW PRINT SPEED We got a HP Latex 560 back in 2020 and its always printed super slow no matter the print speed. We are comparing this with our much older HP 360 which can sometimes print twice as fast...

Wow literally no one replied to this post. HELLO! HELP

If that had been the case then I dont think we would have had instant success after switching from BriteLine to General Formulations. We have never gone back. Happy with the GF. Material always seems to be consistent. Also I don't know if we have ever tried going back to using the 80/20...

Sorry the video isn't great but I got this about a month ago while both the 360 and 560 where running. And what you can see in the video is the typical behavior that we expect out of each machine. One is running vinyl while the other is running poster paper but both are on 12 pass. Before...

Yeah I know. But I'm just now seeing all these responses. Also didnt see where anyone answered you.

Any updates? IS your 570 fast? Like do you know your square footage output per hour?

I can totally relate to this! #PRINTLIFE

Whats wrong with a premade profile? Are you saying its better to just start with one of the generic profiles that are already installed on the 560 and tweek it from there?

Are you asking what the percentage amount should be for the perf?

Yes I agree the GF 270 works great. We switched over to that a few years ago and have not had the same issues since.

You have run both the 360 and 560? What is your opinion on them? Any major differences aside from the take up reel configuration. Our 560 runs super slow when compared to the 360. The square footage output per hour is often half that of the 360. It doesn't matter which profile or media or pass #...

Do you have any ongoing issues/quirks with your 570? Our 560 has always printed very slowly. Like half the speed that our 360 prints at. And it doesn't matter what profile or material I am using. Its always slow/delayed. We've had ours for 5 years and its never been faster than the 360...