Recent content by kosh_al

what bit did you use?, what movement speed and spindle speed?

Well, I learned something new today. I did not realize they have two models of the standard router!

Phil, have you tried routing the .040 aluminum with any of the coated bits? I've seem some coated bits advertised as being able to cut aluminum without active cooling.

The standard router and the HF router are definitely not the same. The HF router has a balanced pneumatic collet and pneumatic air cooling of the collet and motor, allowing for higher RPMs and more versatility and finer finishes in materials that can be cut (see Phils post above with brochure...

Unfortunately the Summa tech was only here for three days. He diagnosed our issue as a bad regulator and said we shouldn't use the router until this was fixed, so we got no router training and ordered the part. Turns out the issue was something else that the Summa tech missed and I was able to...

Some sort of manual would be nice so I can verify the connections to the HF router. There are two air lines going to the router. A clear blue line goes into the top of the router and a solid black line goes into the base of the router. The clear blue line comes out of pressure switch #5 under...

That is what our Summa tech told us when he came out to set up the machine and the secondary wont go down to .125 (air just blows by and out). Summa guy said the pressure regulator is bad and need replaced before using router. We got the new part and the behavior is exactly the same (air blow...

Any luck? I am trying to find settings/procedures for the adjustable air pressure regulators underneath the table for the HF router, etc.

That's good to know if we ever end up getting the POT to consider the mods we'd have to do to our setup. We opted to buy the EOT.

Can you share documentation that says the Air Dryer has to be active instead of manual? The pre-installation guide we have and the F Series user manual we have don't say anything about active/passive, just "The air quality should be clean and dry and filtered to 15 microns.", which we have an...

We have a manual dessicant air dryer/oil remover in line between the compressor and the table, so dry, oil free air is no issue. What I was saying are that the specs for the HF router show that it is not a pneumatically driven router, it simply uses pneumatic pressure to operate the collet...

Phil, from what I read in the Summa F Series User Manual Rev15 (page 1-19, section 1.5.6), the HF router appears to still be an electric motor (like the standard router) with a pneumatic "clamp" for the collet for the bit. I imagine since it is just the collet using the air pressure, that a...

We do see the option in production manager to add the Summa. There are a couple options to add, "Summa F Series" or "GoProduce"? Also, we do have the pro pack for GoProduce, care to elaborate on how it makes it easier?

Bump! Did nobody have an answer for this?