I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Solventinkjet,
Thanks for your informative reply. I swapped the motherboard with a spare that I had on a printer I was refurbishing. and all heads are firing properly. So There must be something going on with my original mainboard. I can rule out everything past the mainboard (carriage...
Greetings Folks,
Could use a bit of help troubleshooting my SP300. A week or so ago out of the blue, the printer stopped printing Yellow. Relatively new printhead. I first attempted to draw some ink through the printhead with my syringe, and performed a powerful cleaning. Did not solve the...
Greetings Folks,
Sorry for the poor quality images, all my friend gave me was a rubbing of the old image from the raised paint where the vinyl letters used to be on the gelcoat of his boat!
Could someone please identify the following fonts.
As usual - Thank you all most kindly.
-todd
Greetings folks,
anyone know of a substitute or replacement ink drain bottle that will fit my SP300. I think roland uses the same bottle for a wide variety of their machines, the part number in the manual is: 11369115
Just wondering if anyone had a substitute that might work.
thanks!
-t
Greetings Folks,
I know they are pretty poor quality photos, unfortunately It's all I have to work with! Could someone kindly help me identify the two fonts: As Usual, thanks Kindly for your help.
-t
I think the material I was using from them was like 5 mil Calendared vinyl. I was just using it from general sign printing. I think I was paying somewhere like $150.00 for a 54" 30yd roll?
Greetings folks,
Does anyone have a decent recommendation on a replacement supplier for the air release print vinyl I used to get from the great folks at InstantOne media?
too bad they shut their doors.
thanks!
-t
Greetings Folks,
I am having an issue with printing large areas of black on my SP300.
I am using the Versa Settings of:
Quality:
standard
Standard, Generic Vinyl II-B
Preset: Sign & Display
Color Management:
Set Black Leve: +5
Test Print shows no issues with black printhead.
My black...
Hi folks,
what blade offset do you use for a 45 degree blade and a 60 degree blade. for a 45 I use .250mm in versaworks. Flexi wants the offset in inches. I converted the .250mm to inches and t gave me 0.0098
I set that into flexi as .01 but am still getting horns on my corners?
can you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.