Recent content by Michael Barbare

Roland vp 540 Continually blows Fuse F1 on main board Install new fuse turn main power on fuse is still good Turn secondary power switch on and fuse blows immediately I disconnected all 4 print heads install new fuse turn power on at rear fuse is good turn power on front blows fuse I...

Main board fuse #1 what is it the fuse for ?

main board fuse F1 If you turn main board over it has printed r329 Fuse F1 what is it the fuse for

Roland vp540 Main board circuit r329 leads to where on the printer

Roland vp540 main board fuse F1 continues to blow Should I replace main bored or print heads for magenta and yellow

Roland VIP-540 Main power board has 3 fuses 1.3 amp 250 volt Should both ends of the fuse have power all the time If they don't does this mean the main board is bad

A car accident took out a power line and the power to the shop makes sense about the fuse I know that there are 2 glass fusses on the bored are there any others ?

So I have done the suggestions and double checked the cap tops Is it possible the print head needs to be adjusted I moved this printer with me about a 2 hour drive down the interstate I did put the print head lock on it and prepare it for transport But since it have been set up at new...

Help Roland vp540 Always use Roland ink and parts Magenta and yellow stop printing at same time I did manual clean Installed new cap tops all 4 Pulled vacuum on magenta and ink comes through Pulled vacuum on yellow and it will not pull ink through into the syringe